I've found documentation about 2.4 Ghz flat panel antenna
(http://www.dd-wrt.com/phpBB2/viewtopic.php?t=5026)
Parts List :
- PCB 25cm*25cm
- Reflector - 283 x 283 metall plate distanced at 5 mm from CUPRUM LAYER of our PCB!!
- N-female connector
just solder N-type socket in the center of the circle..you can follow the step from this gallery..:)
good luck...
here's a gallery about it:
You can download the corel pattern here
1 comment:
iki nggo opo her?
Post a Comment